Here it is in process....almost there. It is definitely not for beginners. There are a lot of pieces and steps, and some areas are a little vague. If you've never seen one up close and touchable, good luck! Watch out for the Peltex fusible stabilizer. It comes double sided, or just one side fusible. I would recommend the single side only. Otherwise you'll need a teflon sheet when you're fusing to the inside of the bag. The next step that is a bit confusing is the magnetic clasp. There is no diagram or picture of where it goes and instructions come with the clasp, not in the bag pattern. I'm going to call it an option. Trying to match the fusible interfacing with the other pieces is like chasing a magnetic bumble bee with a magnetic wand, an old game called Tickle Bee. I'm trimming as I go to keep things even.
This is the outside with stitching on the bottom...
This is the lining with the clasp installed.
The handles are black and are sewn on...
Check back in a few days for the finished pictures. Thanks for looking.
This is the outside with stitching on the bottom...
This is the lining with the clasp installed.
The handles are black and are sewn on...
No comments:
Post a Comment